gefran TPD32-EV-...-2B, Instructions Manual

Page: 302 / 504

—————— TPD32-EV ——————
302
The parameter Speed ref 1 will set in RPM x 4, so:
PID out scale = (2550 x 4) / 8500 = 1.2
Set PI central v sel = 1.
Set PI central v 1 = 1
In absence of a correction performed by the PI block of the regulator, the line speed reference (Feed-forward)
must be multiplied by 1 and sent directly to the speed regulator of the drive.
In this application, the regulator carries out a mono type proportional control. The correction will be indicated
in percentage, according to the line speed, from 0 to the maximum.
Set PI top limit and PI bottom limit so that, with max. of the dancer (max.value of the analog input 1 = PID
Feed-back ) and setting the proportional gain of the PI block at 15%, it will correspond to an equal proportional
correction of feed-forward. For this reason set:
PI top limit
= 10
PI bottom limit = 0.1
Set PI P gain PID = 15%
Set PI I gain PID = 0%
With this configuration, having a correction proportional to the line speed, the PI block is not able to position the
dancer at speed = 0. In order to do the drawing in stop conditions, it is necessary to use the PD block.
Set
PD P gain PID
to a value that allows positioning of the dancer without large dynamic variations.
For example:
PD P gain PID = 1%
If necessary, use the derivative component as damping component of the system, setting for example:
PD D gain PID = 5%
PD D filter PID
= 20ms
If not necessary, keep these parameters = 0.
If it is necessary to carry out a reference cascade for another drive, set PID output on an analog output, for
example:
Analog output 1 / Select output 1= PID output
(with Real FF PID = 10000 count, Analog output 1 = 10V).