GE Brivo OEC 715, Service Manual, Page: 490 / 551

Periodic Maintenance
8-3
X-radiation Exposure
The X-ray tube assembly produces X-radiation when energized. Never operate this device without X-ray
shielding in place. Use lead shielding and draping to protect personnel.
Lead aprons, radiation monitors, and appropriate radiation shields must be utilized for
the protection of all personnel in the vicinity while performing tests. Living human
anatomy should never be used as a phantom or demonstration aid. Do not produce
radiation in hallways.
Many of the PCB's in this system contain components, which are sensitive to Electro-
Static Discharge (ESD). Observe ESD safety procedures.
8.1.2. Tools and Test Equipment
In addition to standard service tools and test equipment, the following special tools and test equipment
are required to complete the PM procedure.
Standard Tool
Item Tool
1 Oscilloscope Tektronix 2236 or equivalent
2 Multimeter or equivalent
3 Spatial Resolution Tool
4 Lead Apron
5 kV meter
6 Dosimeter
7 Ampere meter or equivalent
8 Ruler longer than 12 inches (30cm)
9 Erasable marker (whiteboard marker)
10 mAs meter
11
Precision flat head screwdriver (
∅
3mm or less) to adjust camera iris, focus
12 Transparent adhesive tape, with cutter (or need scissor or knife to cut the tape)
Special Tool
Item Tool GE part number
1 Three copper sheets, each 1mm thick 00-877682-01
2 9-inch BAFT Tool or UBAT 00-878105-02 or 5307604
3 PWA, extend board 5085609
WARNING
CAUTION