Fukuda DYASCOPE 8000 Series, Operation Manual

Page: 214 / 349

12-2
Chapter 12 Printing Printing Condition/Output Destination Setup
002", "CNT-004", "CNT-006", the printing operation from "BED-001" will output the printing
on the "CNT-002" central monitor.
Printing Condition/Output Destination Setup
Manual Printing Setup
The manual printing can be set to start from the time the key is pressed, or 8 sec./16 sec. prior to the time the key is
pressed.
Also, the printing can be set to automatically stop after 12 or 24 seconds, or continue to print until the "Print Start/
Stop" key is pressed again.
1
Press the [Menu], [Print Settings] ("Each Bed") keys, and press the [Setup] key for the patient to perform the
setup.

The manual printing setup window for the selected patient will be displayed.
2
Output Waveform Selection
 Maximum of 3 waveforms can be selected for printing. When selected, the key will be displayed in blue.
3
Print Duration

[12sec.]/[24sec.]: Printing will automatically stop after 12 seconds or 24 seconds.
 [Cont.]: Printing will continue until the [Print Start/Stop] key is pressed again or until paper runs out.
4
Delay Time

[None]: Printing will start from the point the [Print Start/Stop] key is pressed.
 [8 sec.] / [16 sec.]: Printing will start 8 sec. or 16 sec. prior from the point the [Print Start/Stop] key is pressed.
1
2
3
4
5