Fukuda DYASCOPE 8000 Series, Operation Manual

Page: 216 / 349

12-4
Chapter 12 Printing Printing Condition/Output Destination Setup
 [OFF]: Printing will not start at alarm occurrence.
3
Alarm Factor Selection
 Select the alarm factor for alarm printing. When selected, the key will be displayed in blue.
 The alarm OFF mark will be displayed inside the key for the parameter in alarm OFF condition.
 [Select All Arrhythmia]: All arrhythmia factors will be selected.
 [All ON]: All alarm factors will be selected.
 [All OFF]: All selections for the alarm factor will be cancelled.
4
Output Waveform Selection
 Maximum of 3 waveforms can be selected for printing.
 [Alarm]: Prints the waveform of the alarm factor.
(

"Alarm Factor and Printed Waveform" P12-4)
5
Print Duration
 [12sec.]/[24sec.]: Printing will automatically stop after 12 seconds or 24 seconds.
 The delay time differs depending on the print duration.
6
All Beds
 Applies the same setting for alarm printing to all beds.

Alarm Factor and Printed Waveform
Print Duration
Delay Time
Adult Child
Neonate
Numeric Data Alarm Arrhythmia Alarm
12 sec.
12 sec. 12 sec. 8 sec. 12 sec.
8 sec. for the multigas unit alarm
24 sec. 16 sec. 16 sec. 16 sec. 16 sec.
Alarm Factor Printed Waveform Alarm Factor Printed Waveform
Numeric Data Numeric Data
HR ECG1, ECG2 SpHb SpO
2
ST1, ST2 ECG1, ECG2 SpHb-2 SpO
2
-2
ST(I) to ST(V6) ECG1, ECG2 InspO
2
, ExpO
2
O
2
BP1 to 8, CVP BP1 to 8 InspN
2
O, ExpN
2
O CO
2
NIBP - InspAGT, ExpAGT AGENT
SpO
2
SpO
2
InspAGT2, ExpAGT2 AGENT
SpO
2
-2 SpO
2
-2 MAC AGENT
PR SpO
2
Arrhythmia
PR-2 SpO
2
-2 Asystole ECG1, ECG2
RR RESP (Other than CO
2
source) VF ECG1, ECG2
CO
2
(CO
2
Source) VT ECG1, ECG2
APNEA RESP (Other than CO
2
source) Slow VT ECG1, ECG2
CO
2
(CO
2
Source) Run ECG1, ECG2
EtCO
2
, InspCO
2
CO
2
Couplet ECG1, ECG2