Fukuda DYASCOPE 8000 Series, Operation Manual, Page: 143 / 349

8-5
Chapter 8 Parameter Setup ECG
below -20 mm / -2.0 mV is set, the lower alarm will turn OFF.
Size / Lead

Adjustment of Waveform Size and Baseline Position
Adjust the waveform size and baseline position.
CAUTION
 Automatic size of the ECG is effective only at the time the [Auto] key is pressed. This does
not continually adjust the size.

The waveform size cannot be set if the waveform is not displayed. Change the display
configuration as necessary.
(

"Numeric Data/Waveform" P13-4)
1
Press the key for "ECG1" to "ECG12".
 The "Size" screen will be displayed.
 When the display layout is "12-Lead", the waveform size can be set
differently for limb leads and chest leads.
2
Select the waveform size for displaying and printing.

[Auto]: ECG amplitude will be automatically adjusted to 10mm.
The automatic adjustment is effective only when the [Auto] key is
pressed.
3
Use the / keys to adjust the baseline position.
If the waveform is difficult to see due to ECG amplitude, set the baseline position to 0mV. The baseline position
for the waveform display and printing will be adjusted. When the display layout is set to "12-Lead", the baseline
position cannot be changed.
Waveform Size x1/4 x1/2 x1 x2 x4
Voltage (10mm) 4mV 2mV 1mV 500μV 250μV
3
2