Fukuda DYASCOPE 8000 Series, Operation Manual, Page: 41 / 349

xxi
Safety Telemetry Precautions
Telemetry Precautions
For proper management of the telemetry installation, consult your Fukuda Denshi representative concerning the
following.
 Plan the installation of your telemetry system, taking into account your entire medical facility needs and plant
requirements.
 Be sure the antenna system installed meets the facility and plant requirements.
 The Radio Frequency device is susceptible to interference from other outside sources. Interference may prevent
the monitoring of patients connected to this device. If problems exist, contact your local service representative.
 Note: This device operates in the 600MHz UHF band. The exact frequency of operation depends on the
destination, and has been preset for your facility, and may be identified by cross-referencing the channel
designator on the device with the Telemetry Channel-Frequency Table in the transmitter operating manual.
 The manufacturers, installers and users of WMTS equipment are cautioned that operation of this equipment
could result in harmful interference to other nearby medical devices.
 Users are advised to periodically contact the FCC or specified frequency coordinator and determine if your
transmitter frequencies may cause interference.
 To assure safe and reliable operation, observe the following precautions:
 Be sure that no other devices are using the frequency assigned to this transmitter.
 This device is susceptible to interference from electrosurgical knives and other computerized equipment. If
problems occur, contact your local Fukuda Denshi service representative.
 Any obstruction such as reinforced concrete or large metallic surfaces between the receiver and the
transmitter can affect reception. If problems occur, contact your local Fukuda Denshi service representative.
 When a low battery alarm occurs, replace the battery in the transmitter.
WARNING
CAUTION