Fukuda DYASCOPE 8000 Series, Operation Manual

Page: 37 / 349

xvii
Safety Electromagnetic Compatibility
EMC Guidance
This device complies with the Safety Standard IEC 60601-1-2: 2007. However, if portable transmitter or wireless
LAN equipment is used extremely nearby, the electromagnetic influence may largely exceed the compliance level
and may cause unexpected phenomenon such as noise interference on the waveform, etc.
Also, if this equipment is installed close to, or stacked with other equipment, malfunction may occur. Make sure to
verify that the equipment operates properly in a used location.
This equipment should be used in a location specified by each medical institution.
If any unexpected noise interference on the waveform or failure to the peripheral device occurs, stop using the
equipment and follow the instruction of the technical engineer.
The following is the information relating to EMC (Electromagnetic Compatibility).
(When using this equipment, verify that it is used within the environment specified below.)

Compliance to the Electromagnetic Emissions
The DS-8900 System is intended for use in the electromagnetic environment specified below. The customer or the
user of the DS-8900 System should assure that it is used in such an environment.
Guidance and Manufacturer's Declaration - Electromagnetic Emissions
Emissions Test Compliance Electromagnetic Environment - Guidance
RF Emissions
CISPR 11
Group 1
The DS-8900 System uses RF energy only for its internal
function. Therefore, its RF emissions are very low and are not
likely to cause any interference in nearby electronic equipment.
RF Emissions
CISPR 11
Class A
The DS-8900 System is suitable for use in all establishments
other than domestic and those directly connected to the public
low-voltage power supply network which supplies buildings
used for domestic purposes.
Harmonic Emissions
IEC 61000-3-2
Class A
Voltage Fluctuations/
Flicker Emissions
IEC 61000-3-3
Complies