Fujitsu PRIMEQUEST 400 Series, Installation Manual, Page: 44 / 446

1-2 C122-E001-10EN
CHAPTER 1 PRIMEQUEST Overview
Figure 1.1 Setup workflow
Notes: Before the user can start setup tasks, certified service engineers must have
executed tasks including machine setup, the part of MMB setup they are
responsible for, and test program execution.
Equipment setup
z
Perform inventory checking and BIOS setup and
check partitions using a test program.
z
Testing is conducted in a created test environment.
MMB connection (test
environment)
Tasks performed by
certified service
engineer
Tasks performed by
the user
Saving settings
z
Setup the MMB IP address and other parameters to
be used for normal operation and connect to the
MMB. See
Section 2.2.1 .
z
Specify parameters for the entire MMB, such as the
user accounts and system name. See
Section 2.2.4 .
z
Set the partition names or configure the partition.
See
Section 2.5 .
z
Set up the mode when necessary. See Section 2.5.8 .
z
Save the specified setting values (for MMB and
GSWB). See
Section 2.6 .
z
GSWB is supported only in PRIMEQUEST 580A/
540A/580/540/480/440.
GSWB initialization
MMB connection and setup
(operating environment)
Network setup for normal
operation
MMB initialization
Partition initialization
Mode settings
z
Install the operating systems. See Chapter 3 .
z
Specify the monitoring method, dump environment,
and save the settings (PSA and EFI). See
Chapter 4 .
z
Set up the attached software programs. See
Appendix A .
z
Set up SNMP and security.
See Chapter 5 .
z
Set up GSWBs when necessary. GSWBs can
perform basic functions with as-shipped settings.
Basic functions referred to here mean functions that
do not use a GSWB VLAN (as shipped, VLANs are
not configured). Refer to PRIMEQUEST GSWB
User's Manual (C122-E028EN).
Note: The GSWB is an optional product.
OS installation
Postinstallation work
Setup of attached software
programs
Set up
SNMP security setting
* Only for PRIMEQUEST
580A/540A/580/540/480/440