Fujitsu PRIMEQUEST 400 Series, Installation Manual, Page: 230 / 446

4-44 C122-E001-10EN
CHAPTER 4 Work Required After Operating System Installation
• Using Bonding
Note: Change the VLAN setting of the MMB management LAN hub to "VLAN
Mode." (For details, see 2.2.4.5, Setting a management LAN hub. )
1
Edit the ifcfg file for the relevant interface in /etc/sysconfig/network/. If the file
does not exist, create it. To edit the file, first stop the network.
•
Bonding interface: ifcfg-<bonding-interface-name> Example: ifcfg-bond0
Remarks: If the relevant interfaces for the management LAN are in /etc/
sysconfig/network/, disable them by deleting them.
• File name of the ifcfg file of the interface for the management LAN: ifcfg-eth-id-
<hardware-address>
z
Editing the ifcfg file of the NIC interface for the management LAN
Change or add lines as shown below.
Example: The editing of the ifcfg file shown in the following example assumes
that the Bonding interface is ifcfg-bond0.
Then, enter "start" for the network service to activate the Bonding interface.
Command syntax:
# rcnetwork stop
# rm /etc/sysconfig/network/ifcfg-eth-id-
<hardware-address>
..
# vi /etc/sysconfig/network/ifcfg-
<bonding-interface-name>
ifcfg-bond0:
BOOTPROTO='static'
MTU=''
REMOTE_IPADDR=''
IPADDR='192.168.16.138'
# Same subnet as the MMB
NETMASK='255.255.255.0'
BROADCAST='192.168.16.255'
STARTMODE='onboot'
BONDING_MASTER=yes
BONDING_SLAVE_0='bus-pci-0000:01:08.0'
# bus-info number for management LAN NIC#0
BONDING_SLAVE_1='bus-pci-0000:01:00.0'
# bus-info number for management LAN NIC#1
BONDING_MODULE_OPTS='arp_interval=1000 arp_ip_target=192.168.16.111,
192.168.16.112 mode=1'
# external switch IP address
rcnetwork start