Fujitsu PRIMEQUEST 400 Series, Installation Manual, Page: 279 / 446

C122-E001-10EN 4-93
4.6 PSA Installation (Windows Server 2003) (PRIMEQUEST 520A/520/420)
4.6.5 Setting Watchdog monitoring after a STOP error (a fatal system
error) occurs
If a STOP error (a fatal system error) occurs in the system, the results are as follows:
PRIMEQUEST 520A/520/420
•
"Panic" is displayed for "System Progress" of the relevant partition in [Partition]-
[Power Control] of the MMB Web-UI.
•
A memory dump is collected in the system.
In such cases, to prevent the system from freezing or otherwise becoming non-
responsive, monitoring using the Watchdog timer can be set.
When the specified time has elapsed, the MMB executes a Hard Reset, and the OS is
rebooted.
Setting procedure
1
Open the following file:
[PSA installation folder] \etc\opt\FJSVpsa\usr\pnwatchdog.conf
(Example: C:\Program Files\fujitsu\FJSVpsa\etc\opt\FJSVpsa\usr
\pnwatchdog.conf)
2
Specify a key value as shown below. The default is 0.
Section: [WATCHDOG]
Key: [TIMER]
Set value (unit: seconds) 0 (Watchdog timer not used)
1 to 6000 (Watchdog timer monitoring time)
Remarks: For the set value, measure the time required for memory dump in the
environment to be applied and determine the appropriate value. If the
required time exceeds 6000 seconds (one hour and 40 minutes),
specify 0 (Watchdog timer not used).
If the set value is shorter than the time required for memory dump
processing, the Watchdog timer expires, resulting in execution of a
Hard Reset, with the result that the memory dump cannot be collected
correctly.