Fujitsu PRIMEQUEST 400 Series, Installation Manual, Page: 244 / 446

4-58 C122-E001-10EN
CHAPTER 4 Work Required After Operating System Installation
•
If PORT is not specified, the default SNMP trap port (162) is used.
Example: When you want to send traps with the community name "public" to port
162 of the manager with IP address 192.168.1.10
z
SNMPv3 trap setting
Define the host that receives the traps (to which traps are sent). If PORT is not
specified, the default SNMP trap port (162) is used.
The major options that can be specified for SNMPCMD_ARGS are as follows:
-v version: Specifies the SNMP version. Specify 3 for SNMPv3.
-e engineID: Specifies the value of oldEngineID in the /var/net-snmp/snmpd.conf file
in the trap sender.
-u secName: Specifies the SNMPv3 account. It must be the same as the setting in the
manager.
-l secLevel: Specifies one of the following according to the security level of
SNMPv3 messages:
Table 4.4 secLevel settings
-a authProtocol: Specifies MD5 or SHA as the protocol used to authenticate
SNMPv3 messages. If SHA is to be used, a package must be
created using openssl that is installed. This option is valid when
authentication is included in the security level specified by the -l
option. It can be omitted if authentication is not included.
trapsink 192.168.1.10 public 162
##SNMPv1 trap setting
trap2sink 192.168.1.10 public 162
##SNMPv2 trap setting
trapsess SNMPCMD_ARGS HOST[:PORT]
#SNMPv3 trap setting
Setting Authentication Encryption
noAuthNoPriv No No
authNoPriv Yes No
authPriv Yes Yes