Fujitsu PRIMEQUEST 400 Series, Installation Manual, Page: 234 / 446

4-48 C122-E001-10EN
CHAPTER 4 Work Required After Operating System Installation
(3) Configuring the NIC for the management LAN (PRIMEQUEST 520A/520/
420)
The connected management LAN NIC must be activated on the partition side for
communication with the MMBs via the management LAN. Configure the NIC by
following the procedure below. Use YaST to configure it.
1
Execute the following command, and record the card name of the NIC for the
management LAN:
Command syntax
Example: In this example, the card name is "Intel Corporation 82562ET/EZ/GT/
GZ - PRO/100 VE (LOM) Ethernet Controller".
2 Execute the following command to activate YaST.
Command syntax:
3
Select [Network Devices] - [Network Card] from the menu, and proceed to the
network card selection window.
4
From the network cards displayed in the [Network Card Configuration] window,
select the card (NIC for the management LAN) that has the name recorded in
step 1.
Note: The name that is recorded in step 1 may not be displayed completely
according to YaST specifications. As shown in Figure 4.7 , "Fujitsu" may
be added in front of the card name, and only the last part of the card name
may be displayed. In such cases, select the name whose displayed
character strings excluding "Fujitsu" matches the last part of the name
recorded in step 1.
/sbin/lspci -s 0000:01:08.0
# /sbin/lspci -s 0000:01:08.0
01:08.0 Ethernet controller: Intel Corporation 82562ET/EZ/
GT/GZ - PRO/100 VE (LOM) Ethernet Controller (rev 04)
# yast