Fujitsu PRIMEQUEST 400 Series, Installation Manual, Page: 236 / 446

4-50 C122-E001-10EN
CHAPTER 4 Work Required After Operating System Installation
4.4.2 Procedures for monitoring syslog
When using SUSE
™
Linux Enterprise Server 10, you must make the addition settings
below.
Note: If you fail to make the settings below before installing PSA, the following
message may be output when you install PSA and PSA may not be able to
monitor driver messages.
syslogd: /var/opt/FJSVpsa/path/syslogd.fifo: Operation not permitted
Remarks: Use the [
↑
] and [
↓
] keys to move the cursor up and down on the YaST
screen.
1 Enter the following command to confirm the active syslog daemon.
If SYSLOG_DAEMON = If "syslog-ng" is displayed for SYSLOG_DAEMON,
/sbin/syslog-ng is running as the syslog daemon.
If SYSLOG_DAEMON = If "syslog" is displayed for SYSLOG_DAEMON,
/sbin/syslogd is running as the syslog daemon.
Record the name of the running syslog daemon.
2 Change the AppArmor settings by following the procedure below:
1
Start YaST.
Figure 4.8 YaST start screen
# grep SYSLOG_DAEMON /etc/sysconfig/syslog
# yast