Fujitsu PRIMEQUEST 400 Series, Installation Manual, Page: 231 / 446

C122-E001-10EN 4-45
4.4 PSA Installation (Linux: SUSE) (PRIMEQUEST 500A/500/400 series common)
To make the management LAN NIC settings effective, PSA need to be restarted.
Command syntax:
• Using PRIMECLUSTER GLS
For the settings to duplicate the management LAN using PRIMECLUSTER GLS,
see the PRIMECLUSTER GLS manual. To use PRIMECLUSTER GLS, specify
the external switches connected to the MMB user ports shown in Figure 4.3 and
Figure 4.4 as the monitored hubs.
Note: If a network has already been configured for the management LAN, use
the IP address specified in the ifcfg file as the IP address for
PRIMECLUSTER GLS and configure the duplication settings by
following the instructions in the PRIMECLUSTER GLS manuals.
After configuring the duplication settings by the GLS, restart the network service
and then restart the PSA.
Command syntax:
• SUSE 10
1
Add the line shown below to the end of /etc/modprobe.conf.local.
Name the Bonding interface (bondN, where N is a number assigned in ascending
order, such as 0, 1, 2...).
*1 For the configuration shown in Figure 4.5 , specify one IP address. For the
configuration shown in Figure 4.6 , specify two IP addresses.
/etc/init.d/y30FJSVpsa stop
/etc/init.d/y30FJSVpsa start
/etc/init.d/y30FJSVpsa stop
/etc/init.d/y30FJSVpsa start
# vi /etc/modprobe.conf.local
Add the following line to the end of the file :
alias <
Bonding interface-name
> bonding
options < Bonding interface-name > mode=1 arp_interval=1000
arp_ip_target= <external-switch-IP-address> // (*1)
options
<Bonding interface-name>
arp_ip_target=<
external-switch-IP-
address(1)
>,<
external-switch-IP-address(2)
>