Fujitsu PRIMEQUEST 400 Series, Installation Manual, Page: 62 / 446

2-16 C122-E001-10EN
CHAPTER 2 Setup
2.2.3 Network settings for actual operation
This section explains the following settings, which are required for actual operation.
Perform these as needed for your operation mode.
z
Setting up the MMB network (PRIMEQUEST 580A/540A/580/540/480/440) (
→
2.2.3.1 )
z
Setting up the MMB network (PRIMEQUEST 520A/520/420) (
→
2.2.3.2 )
z
Specifying Telnet parameters (
→
2.2.3.3 )
z
Setting up the DNS server (
→
2.2.3.4 )
For backing up the settings, see Section 2.6, "Saving Configuration Information."
Remarks: This can be performed by users with administrator privilege.
2.2.3.1 Setting up the MMB network (PRIMEQUEST 580A/540A/580/
540/480/440)
Specify information including the virtual IP address used to access the Web-UI and
the physical IP address assigned to the MMB interface.
Note that this information may have already been set by a Fujitsu certified service
engineer. If the information need not be changed, proceed with the next setting.
Notes:
z
Specify the same subnet for the physical and virtual IP addresses of
MMB#0 and MMB#1.
z
When the virtual IP address is set, and the PRIMEQUEST series machine
is accessed from an external device (for example, from a
Web browser, maintenance terminal, the REMCS, etc.), the access is
performed through the virtual IP address. Therefore, it is impossible to
access the MMB Web-UI by specifying the physical IP address of MMB
#0 or MMB #1.
Remarks:
z
If you make changes to [MMB#0 IP Address] or [MMB#1 IP Address]
and click the [Apply] button in the [Network Interface] window, the
network is temporarily stopped and the Web-UI is disconnected to reflect
the settings. In this case, you can reconnect the Web-UI by making a
selection from the menu.
z
When the IP address is changed, the connection to the MMB Web-UI is
terminated. To use the MMB Web-UI, log in again.