Fujitsu PRIMEQUEST 400 Series, Installation Manual, Page: 215 / 446

C122-E001-10EN 4-29
4.3 PSA Installation (Linux: Red Hat) (PRIMEQUEST 520A/520/420)
4.3.4 Installing FJSVfefpcl
Remarks: FJSVfefpcl is supported only in Japan.
4.3.5 Setting the destination of trap sending from the partition
Notes:
z
Make this setting only if required.
z
The setting is required for linkage with operation management software.
When sending SNMP traps from the partition, you must set the trap send destination.
Add the trap send destination to the snmpd.conf file.
z
Editing snmpd.conf
The settings are detailed below:
z
Setting SNMPv1/SNMPv2 traps
Define the host that receives the traps (to which traps are sent).
•
With this setting made, a cold start trap is sent when snmpd is started. If SNMP
trap sending from the partition is defined, a trap is also sent when authentication
fails.
•
Multiple destinations can be defined by specifying multiple pairs of the trapsink
and trap2sink lines.
• If COMMUNITY is not specified, the character string previously specified by the
trapcommunity directive is used.
The trapcommunity command sets the default community string used to send
traps. When using trapcommunity to set the community string, specify the string
before the pair of trapsink-trap2sink lines.
•
If PORT is not specified, the default SNMP trap port (162) is used.
# vi /etc/snmp/snmpd.conf
Add the following lines for the SNMP version to be used. The lines can be provided in any order.
trapsink HOST [COMMUNITY [PORT]]
# SNMPv1 trap setting
trap2sink HOST [COMMUNITY [PORT]]
# SNMPv2 trap setting
trapsess SNMPCMD_ARGS HOST[:PORT]
# SNMPv3 trap setting
trapsink HOST [COMMUNITY [PORT]]
# SNMPv1 trap setting
trap2sink HOST [COMMUNITY [PORT]]
# SNMPv2 trap setting
trapcommunity STRING
#COMMUNITY name setting