Fujitsu PRIMEQUEST 400 Series, Installation Manual, Page: 333 / 446

C122-E001-10EN 4-147
4.12 OS Backup Settings
z
When a tape unit connected to the remote host is used
1
Start the network.
2
Activate the network.
\: Indicates that no line feeds should be inserted.
Remarks: Set values such as the IP address according to your system.
3
Prepare a tape unit.
Use the mt command with the ssh command for operation with a remote tape
unit.
For details, see the mt command manual.
• Rewind tape.
Enter the password in response to the password prompt.
4
Back up.
Use the ssh command for the backup operation.
•
For a file system other than /boot/efi
Back up with the dump command.
Enter the password in response to the password prompt.
•
For /boot/efi
Back up with the tar command.
Enter the password in response to the password prompt.
# /etc/rc.d/init.d/network start
# ifconfig eth0 xxx.xxx.xxx.xxx netmask xxx.xxx.xxx.xxx
broadcast\
xxx.xxx.xxx.xxx
# ssh remote-host-name mt -f /dev/nst0 rewind
# dump 0f - /dev/sda2 | ssh
remote-host-name
dd of=/dev/nst0
# cd /boot/efi
# tar czvf - . | ssh
remote-host-name
dd of=/dev/nst0