Fujitsu PRIMEQUEST 400 Series, Installation Manual, Page: 49 / 446

C122-E001-10EN 2-3
2.2 MMB Connection and Setup
2.2 MMB Connection and Setup
When you start MMB setup, the MMBs are in a test environment constructed by a
certified service engineer, and test programs have been executed in it. Therefore, you
need to reset the MMBs for actual operation.
More specifically, you need to specify MMB IP addresses and connect cables
assuming actual operation. After the MMBs are connected, use the MMB Web-UI
(Web user interface) to register and specify the user accounts, security parameters,
time, and other MMB settings.
The figure below shows the MMB connection and setup flow.
2.2.1 Connection environment settings for actual operation
The connection environment for testing must be reset for actual operation. You need
to perform the following operations:
z
Specifying the IP address for the PC to be used as the MMB console (
→
2.2.1.1 )
z
Connecting the MMB console PC to the MMB user port (
→
2.2.1.2 )
z
External LAN connection for PRIMEQUEST (PRIMEQUEST 580A/540A/580/
540/480/440)
(
→
2.2.1.3 )
Connection environment settings for
actual operation
→
2.2.1
Network settings for actual operation
→
2.2.3
MMB initialization
→
2.2.4
z
Set up the connection environment for actual
operation.
z
Set up the network and Web server to be used
for actual operation.
z
Registration of user accounts
z
Setting user account of certified service
engineer
z
Setting system name
z
Setting date and time
z
Setting Telnet
z
Setting a VLAN in a administration LAN hub