Fujikura 90S, Instruction Manual

Page: 99 / 105

FUSION SPLICER 90S Rev5
98
Error Message List (5 of 8)
Error Message Reason Solution
Thin Fiber
･ Inadequate arc power
･ Calibrate the arc power with
the [Arc Calibration] function.
･ Prefuse power or time is
set too high
･ If using the Special mode,
adjust or initialize [Prefuse
Power] or [Prefuse Time]
settings. For normal splice
mode, the prefuse is fixed
and cannot be adjusted.
･ Insufficient [Overlap]
setting
･ If using the Special mode,
adjust or initialize [Overlap]
setting. For normal splice
mode, the overlap is fixed
and cannot be adjusted.
･ Execute [Motor Calibration]
function in the maintenance
menu to calibrate the stuff
amount.
Fat Fiber
･ Too much [Overlap]
setting
Too Tapering
Fiber
･ Too much fiber taper.
･ If using the taper splice
function, the error message
may appear meaning the
fiber is tapered too much.
Bubble
･ Bad fiber end-face.
･ Check the condition of fiber
cleaver. When the blade is
worn, rotate the blade.
･ Prefuse power or time is
set too low
･ If using the Special mode,
adjust or initialize [Prefuse
Power] or [Prefuse Time]
settings. For normal splice
mode, the prefuse is fixed
and cannot be adjusted.
Error Message List (6 of 8)
Error Message Reason Solution
Large Dust
Burn
･ Bad fiber end-face.
･ Check the condition of the fiber
cleaver. If the blade is worn,
rotate the blade to a new position.
･ [Cleaning Arc] time
is too short or
“OFF.”
･ Dust still present after cleaning
fiber or cleaning arc. Clean fiber
thoroughly or Increase [Cleaning
Arc Time]
High
Estimated
Loss
(1/2)
･ Insufficient fiber
cleaning.
･ Dust or dirt on the fiber surface
results in bad splice loss and low
tensile strength.
･ Clean the fiber surface sufficiently.
･ Do not clean the fiber after
cleaving to prevent dust on the
fiber end-face.
･ Avoid any contact with the fiber
end-face.
･ Bad fiber end-face.
･ Check the condition of fiber
cleaver. If the blade is worn,
rotate the blade to a new position.
･ Confirm the [Cleave Limit] setting.
2.0° or less is recommended.
･ Dust or dirt is on the
V-groove or the
clamp chip.
･ Dust or dirt on the V-groove or
clamp chip causes poor fiber
movement during fiber stuffing.
Clean them periodically.
･ Dust or dirt is on the
lens
･ Execute the [Dust Check]. If dust
or dirt exists, clean the lenses.
･ Bad electrode
condition.
･ Replace the electrodes if they
appear worn (rounded tip shape),
dirty or bent.