FUSION SPLICER 90S Rev5
31
Select of the Splice mode
The optimal splice setting for a specific fiber combination consists of the splicing
parameters listed below. In other words, the optimal splicing parameters depend
on the fiber combinations, and are different depending on the fiber used.
Parameters for controlling arc discharge.
Parameters for calculating estimated splice loss.
Parameters for controlling fiber alignment and splicing procedures.
Threshold for error messages.
A series of optimal splice parameters for major fiber combinations are already
stored in the fusion splicer. These parameters are stored in the database area
and can be copied to the user-programmable area. These fusion splice
parameters can be edited for a specific fiber combination.
How to check the splice mode
The current splice mode is displayed in the monitor as shown below
How to change the splice mode
Select an appropriate splice mode for type of fiber to be spliced.
1.
Select Splice Mode icon at [READY] state. The [Splice Mode] screen
appears.
2.
Select the suitable splice mode in the list.
3.
The color of the selected icon change to blue.
How to select the “Splice mode”
[AUTO SM/NZ/DS/BIF/MM]
Use this mode if the fiber type is not identified.
[** AUTO]
Use this mode if the fiber type is identified.
[** FAST]
Use this mode if the fiber type is identified and prefer
quick splice with high yield to consistent splice loss.
[SM-SM] and others
Use this mode for splicing special fibers.
This mode enables to set specific parameters for each
splicing.
Execute [Arc Calibration] before using this mode.
Touch the mode to be selected
Select “Splice Mode”
Changed
