FUSION SPLICER 90S Rev5
36
Set the fiber onto fiber holder
1. Open the lid of a fiber holder and then set the fiber in the fiber holder.
2. Adjust the fiber position and then close the lid of the fiber holder. The position
of the fiber is dependent on the fiber holder as shown below.
In case of Fiber holder “
FH-70 series
”
Use either the edge or the extruded nose of the fiber holder as the reference
point. Adjust the position of the sheath edge as follows:
If the reference point used is the edge of the fiber holder, set the fiber in
the fiber holder with the fiber coating 3.0mm from the edge of the fiber
holder.
If the reference point used is the extruded nose of the fiber holder, set the
fiber in the fiber holder with the fiber coating 1.5mm from the extruded nose
of the fiber holder.
In case of Fiber holder “
FH-60 series
”
Set the fiber in the fiber holder with the fiber coating 3.0mm from the edge of
the fiber holder.
Fiber Cleaving
1.
Lift the Lever until it stops. The blade is automatically set at the start position
and is now ready to cleave the fiber.
Select a suitable fiber holder based on the fiber coating diameter.
If fiber coating has some memory curl, place fiber so that the curl
is pointed downwards.
Close the lid of a fiber holder while pressing down with a finger
on the coating (refer to figure above).
Adjusting coating edge
3.0mm
Pressing down with a finger
Adjusting coating edge
1.5mm
3.0mm
Select a suitable fiber holder based on the fiber coating diameter.
If fiber coating has some memory curl, place fiber so that the curve of
memory is turned downwards.
Close the lid of a fiber holder while pressing down with a finger on the
coating (refer to figure below).
Lever
Pressing down with a finger