FUSION SPLICER 90S Rev5
42
Storing splicing results
Splicing results is stored in memory.
Storing results automatically
The splice result is automatically stored in memory when RESET is pressed
upon completion of the splice at the [Finish] screen or when the wind-protector is
opened upon completion of the splice at the [Finish] screen.
If a comment is entered, the same comment is recorded into subsequent splice
results. To change comments, see the next paragraph.
How to input Mode Title/Comment/Password
Character list below is displayed by selecting Mode Title / Comments /
Password.
1.
Input the selected character by using the keypad in the monitor.
2.
Select icon on completion of inputting characters.
3.
In the case of Password input, the next screen image is displayed if
the correct password is input. If the input password is incorrect, the
previous screen image is displayed.
Fiber proof test
The strength of the splice point can be checked. After splicing, a proof-test is
performed by pressing the SET key or opening wind-protector. If the operation
mode is set to “Auto” or ”Auto-LR”, a proof-test will be performed automatically.
Using the fiber retention clamp
When using the “fiber retention clamp” function, the fiber is held even though
sheath clamps open.
Picking up the fiber automatically releases the “fiber retention clamps.”
Motion changes by the
selected operation mode.
When a [Proof test] setup is
OFF, sheath clamp will not
open after splicing.
After the 20,000th result is stored, 20,001st splice result is written
over first result.
Picking up the fiber. Clamp automatically releases