FUSION SPLICER 90S Rev5
22
AC generators commonly produce abnormally high AC output voltage.
Measure the output AC voltage with a circuit tester before connecting
the AC power cord. Such abnormally high voltage or frequency from
a generator may cause fuming, electric shock or equipment damage
and may result in personal injury, death or fire.
Check the AC voltage
before inserting the power
cord to generator.
Power supply
The fusion splicer can be operated with AC power supply or battery.
Insert or detaching power unit
Inserting power supply unit
Insert power unit into the power unit dock until it stops into place.
Detaching power supply
Turn off the fusion splicer before removing the power unit.
Take the cover off and then hook a finger on the bottom of the power supply unit
and remove the power supply unit from the fusion splicer body.
AC Operation
1. When operating the fusion splicer with AC power, use AC adapter (ADC-20)
and AC power cord (ACC-xx), or either Power Unit of the following;
Battery Pack (BTR-15) or DC adapter (DCA-03).
*The Battery pack (BTR-15) can use while charging.
2.
Attach the power unit into the fusion splicer body and put the cover on it.
3.
Insert the AC power cord into the AC inlet of the AC adapter.
4.
Insert the supply terminal of the AC adapter into the inlet of the power unit.
Hook
(Rear side)
Pull out
Take cover off
AC Adaptor [ADC-
20]
Battery pack
or DC adapter
AC adaptor
[ADC-20]
AC power code
[ACC-**]
