FujiFilm ClearView CS, Service Manual

Page: 171 / 1404

Error
Code
Error Name Occurrence Condition
Analysis
Flow
CR-IR 363
Service Manual
MT-14
MT-14
011-202-04
11.15.2004 FM4425
10261 Polygon rotation error (1)
During bootup, error for the polygon lock signal (PONL, POKL) is detected so that the polygonal mirror function is
disabled. The start-point detection (SYN) and leading-edge detection (SED) functions are also disabled (detail code:
903403, 003400, 902403).
{MT:5.8}
10271 Laser unlit error (1)
During bootup, the laser (LDD) and start-point detection (SYN) functions are disabled due to blow of the fuse (G011
and H011 on the SCN17A/SCT17B board) or laser failure (detail code: 805413, C05413, 00503).
{MT:5.9}
10281 Start-point detection error (1)
During routine processing or during self-diagnostics, because the signal from the start-point detection (SYN) is
faulty, the SCN17A/SCT17B board does not operate normally (detail code: 801C03).
{MT:5.10}
10283 Scanning optics unit board error
(1)
For self-diagnostics prior to reading during routine processing, the SCN17A/SCN17BA board diagnostic error
associated with polygon error is detected.
The laser is unlit due to a disconnected connector at the scanning optics unit, etc., so that an error related to the
polygon error occurs, as well.
{MT:5.8}
10293 Printed board type error
During bootup, an invalid SCN board type is detected. (SCN17A board is installed in CR-IR 363.)
<Action>
Check the scanner board. Mount the SCT17B board if a different board has been mounted.
-
10294 H8 CPU version error
During bootup, an invalid H8CPU version on the SCN17A/SCT17B is detected.
{MT:5.15}
10298 Scanner retry error
During bootup, because the scanner-related error is detected, the IP is returned to the cassette and the scanner is
initialized.
The routine processing is retried again, but the scanner-related error recurs.
{MT:5.11}
10343 IP barcode reading retry error (2)
During routine processing, the IP transport motor (MB2, MC3) is driven for barcode reading retry operation (return
conveyance), but the side-positioning entrance IP sensor (SG1) does not transition to CLOSE within the specified
period of time.
{MT:4.1}
10344 IP barcode reading retry error (1)
During routine processing, the IP transport motor (MC3) is driven for barcode reading retry operation, but the side-
positioning IP sensor (SC3) does not transition to CLOSE within the specified period of time.
{MT:4.1}