FujiFilm ClearView CS, Service Manual

Page: 56 / 1404

Safety Precaution-
15
Safety Precaution-
15
CR-IR 363
Service Manual
011-202-09E
10.24.2011 FM5964
5. Cautions on Electromagnetic
Waves
5.1 Electromagnetic Compatibility (EMC)
This equipment has been tested and found to comply with the limits for medical
devices to the IEC60601-1-2, Medical Device Directive 93/42/EEC.
These limits are designed to provide reasonable protection against harmful
interference in a typical medical installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to other devices in the vicinity.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to other devices, which can be
determined by tuning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures;
- Reorient or relocate the receiving device.
- Increase the separation between the equipment.
- Connect the equipment into an outlet on a circuit different from that to which the
other device(s) are connected.
Consult the manufacturer or field service technician for help.
5.1.1 Further Information for IEC60601-1-2
Model name PROFECT CS/ClearView CS is referred to as CR-IR 363 in this section.
- Medical electrical equipment needs special precautions regarding EMC and needs
to be installed and put into service according to the EMC information described as
follows.
- Portable and mobile RF communications equipment can affect medical electrical
equipment.
- The use of accessories, transducers and cables other than those specified, with the
exception of transducers and cables sold by FUJIFILM Corporation as replacement
parts for internal components, may result in increased emissions or decreased
immunity of the CR-IR 363.
List of Cables
Name FUJIFILM Corporation
Parts code
General Specification
Power Cable
136N0377 (Europe)
136N0376 (UK)
-
I/F Cable -
UTP cable of straight type and
category 5E or more.
- The CR-IR 363 should not be used adjacent to or stacked with other equipment.
If adjacent or stacked use is necessary, the CR-IR 363 should be observed to verify
normal operation in the configuration in which it will be used.
Guidance and manufacturer’s declaration - electromagnetic emissions
The CR-IR 363 is intended for use in the electromagnetic environment specified
below. The customer or the user of the CR-IR 363 should assure that it is used in
such an environment.
Emissions test Compliance
Electromagnetic environment -
guidance
RF emissions
CISPR 11
Group 1
The CR-IR 363 uses RF energy only
for its internal function. Therefore, its
RF emissions are very low and are not
likely to cause any interference in nearby
electronic equipment.
RF emissions
CISPR 11
Class A
The CR-IR 363 is suitable for use in all
establishments other than domestic and
those directly connected to the public
low-voltage power supply network that
supplies buildings used for domestic
purposes.
Harmonic emissions
IEC 61000-3-2 Class A
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Complies