FujiFilm ClearView CS, Service Manual

Page: 1397 / 1404

CR-IR 363
Service Manual
Appx IN-17
Appx IN-17
011-202-11E
06.29.2012 FM6046
Appendix 6. Operation Check for the
15x30 IP Adapter
(#60001 or Later)
u
NOTE
u
Listed below are the abbreviations adopted in this chapter.
- IP of 15cm x 30cm size : 15x30 IP
- IP adapter for IP of 15cm x 30cm size : 15x30 IP adapter
n
Preparation for 15x30 IP adapter
- Use the following serial numbers’ cassettes with 14" x 17" (35 x 43 cm) size for
15x30 IP adapter.
CCWSL17-400001 or later, or CCWSL17-500001 or later
- Paste the label supplied with 15x30 IP adapter on the cassette with 14" x 17" (35 x
43 cm) size for 15x30 IP adapter to prevent from wrong operation.
For details, see the Instruction Manual of 15x30 IP adapter.
n
Confirming the usage environment of the 15x30 IP adapter
Insert the 15x30 IP into the 15x30 IP adapter after exposure, and then insert the IP
adapter into the special 14" x 17" (35 x 43 cm) size cassette.
For details, see the Instruction Manual of 15x30 IP adapter.
u
NOTE
u
Complete the above operation in 20 seconds.
The operation written above need to be operated in a low-lit room, confirm whether
the room is proper or not according to the following procedures.
l
With illuminometer
Illuminance should be lower than 10lux.
l
Without illuminometer
1.
Expose the 15x30 IP at 1mR.
2.
Insert the exposed IP into the IP adapter, and then insert it into the
cassette with 14" x 17" (35 x 43 cm) size.
3.
Confirm the image read from QC/TEST sensitivity menu. Confirm that
the S value is around 200, and there is no artifact which effects on the
diagnosis.
n
Procedures for confirming the transport of IP adapter
1.
Insert the 15x30 IP into the 15x30 IP adapter according to the
Instruction Manual of 15x30 IP adapter.
2.
Insert the 15x30 IP adapter inserted with the 15x30 IP into the cassette
with 14" x 17" (35 x 43 cm) size.
3.
Set the cassette inserted with 15x30 IP adapter onto the RU, and confirm
the reading performs normally.