FujiFilm ClearView CS, Service Manual

Page: 1402 / 1404

CR-IR 363
Service Manual
PC-1
PC-1
011-202-04
11.15.2004 FM4425
CR-IR 363 Performance Check List
The purpose of this performance check list is used at the time of CR-IR 362 installation
to record the steps performed, measured values, and settings, which are based on the
instructions set forth in the Service Manual. This checklist is not supposed to replace
the installation steps set forth in the CR-IR 362 Service Manual but is to be followed
concurrently.
Verify the proper equipment operations at installation and after servicing by checking
the system connection and output image quality (section 9), and then pass the
equipment over to the customer.
Installation Information
Serial Number: ___________________ Software Ver.: ___________________
Site Name:
___________________ Installed by: ___________________
Site Number: ___________________ Signature ___________________
Room Name: ___________________
Installation Date/Servicing Date: ______________
Checklist

3. Preparation for Installation

3.5 Checking the Items Supplied

4.
Installation Procedures

4.1 Removing Tapes from the Machine

4.2 Removing the Light Protect Plates

4.3 Repositioning the Retaining Members

4.4
Installing the Cover

5.
Connecting the Cables

5.1
Connecting the Power Cable and Checking Resistance Value
* Record resistance value measured:
Resistance between L and N: __________ Ω
Resistance between L and E: __________ Ω
Resistance between N and E: __________ Ω

5.2 Connecting the Interface Cable

6.
Final Placement

6.1 Securing the Cable

6.2 Securing the Machine

7. CL Installation Procedures

8.
Installing the RU Software

8.1
Setting the IP Address of the RU

8.2 Setting the CL and Checking Connection
FTP Server

OK

NG
Default Gateway

OK

NG

8.3
Installing Setup PC-TOOL

8.4
RU/CL Software Setup Checkpoints

8.4.1
Checking the CL Software Version

8.4.2 Checking Configuration of the CL - 1

8.4.3 Checking Configuration of the CL - 2

8.4.4
Checking Configuration of the CL - 3

8.4.5
Checking Configuration of the CL - 4

8.4.6
Checking FTP of the CL - 1

8.4.7 Checking FTP of the CL - 2

8.4.8 Checking Setup of the RU

8.5
Installing the RU Software
Software Ver.:
_____

9.
Image/Conveyance Checks

9.1
Check Before Procedures

9.2 Image/Conveyance Checks
ST: X-ray dose:______mR S value:_____

OK

NG
Image irregularities

OK

NG
Shading check

OK

NG
Image format check

OK

NG