FujiFilm ClearView CS, Service Manual

Page: 1361 / 1404

CR-IR 363
Service Manual
IN-28
IN-28
011-202-08E
09.30.2009 FM5540
6. Final Placement
For final placement of the machine, check the requests of the user, and observe the
procedures described below to secure the machine and cables in place.
When the machine is to be secured by use of the anchor nuts, see "Appendix 4.
Securing the Machine with the Anchor Nuts"
6.1 Securing the Cable
CAUTION
If the machine is to be installed in the patient environment, see "APPENDIX 1.
ADDITIONAL PROTECTIVE GROUNDING."
{IN:APPENDIX 1._ Additional Protective Grounding}
CAUTION
Do not tie or bundle the power cable in such a manner that it is overloaded.
1.
Plug the power cable into the outlet.
6.2 Securing the Machine
1.
Secure the four adjustable feet down onto the floor.
u
NOTE
u
When securing the adjustable feet, pay attention to the following points.
- The four adjustable feet should be evenly loaded.
However, if there is too little space on the right and left sides in the machine
installation place to secure the adjustable feet on the rear side, the two
adjustable feet on the front side should be secured in place. In this case, the
two adjustable feet and two casters should be evenly loaded.
- When the adjustable feet are secured, the casters should be detached from the
floor.
2.
Secure the adjustable feet.