FujiFilm ClearView CS, Service Manual

Page: 20 / 1404

CR-IR 363
Service Manual
0.14
0.14
Contents Troubleshooting (MT)
011-202-07
09.30.2008 FM5340
20.5 Checking the Connector Connections .................................. MT-298
20.6 Checking the LCD Panel ...................................................... MT-298
20.7 Check of Cable Connection and Continuity .......................... MT-299
20.7.1 Check Flow .......................................................................................MT-299
20.7.2 Checking the LED on the Power Supply Unit....................................MT-300
20.7.3 Checking Connection of the IMG Board Connector ..........................MT-300
20.7.4 Checking for Continuity of the Cables 1 ............................................MT-301
20.7.5 Checking for Continuity of the Cables 2 ............................................MT-301
20.7.6 Checking for Continuity of the Cables 3 ............................................MT-302
21. Troubleshooting Failures of New IP ............................MT-303
22. Checking the Status of Each Unit ................................MT-304
22.1 Checking the Cassette Set Unit ........................................... MT-304
22.2 Checking the Erasure Conveyer Unit -1 ............................... MT-306
22.2.1 Checking the Tab of the Timing Belt Wheel ......................................MT-306
22.2.2 Checking the Housing and the Bearing.............................................MT-307
22.2.3 Checking the Tension Coil Spring .....................................................MT-307
22.3 Checking the Erasure Conveyer Unit -2 ............................... MT-308
22.4 Checking the Connector on the Scanner Board ................... MT-309
22.5 Checking the Connector on the Scanning Optics Unit ......... MT-309
22.6 Checking the Connector Connection between the Boards ... MT-310
Appendix 1. Procedures for Restoring the Application by
means of DIP SW-No.6 of
the CPU91A Board ...................................Appx MT-1
1. Procedures for Restoring the RU Application .................. Appx MT-1
2. Touch Panel Calibration Procedures ............................. Appx MT-10
Appendix 2. Dimensions in the Conveyance Path ...Appx MT-12
1. Rollers and Sensors Installed in the Conveyance Path .. Appx MT-12
2. General Dimensions of the Conveyance Path .............. Appx MT-12
3. Dimensions of Members in the Conveyance Path ........ Appx MT-13