FujiFilm ClearView CS, Service Manual

Page: 464 / 1404

CR-IR 363
Service Manual
MT-307
MT-307
011-202-07
09.30.2008 FM5340
22.2.2 Checking the Housing and the Bearing
Check the installation of the housing and the bearing from the bottom of the erasure
conveyer unit.
Check to ensure that the housing and the bearing have not fallen from the side plate
of the erasure conveyer unit on the six locations indicated by dotted lines below.
Repair if any has fallen.
22.2.3 Checking the Tension Coil Spring
Check to ensure that the tension coil spring mounted on the location indicated below
is of L=62mm (388N2552).
If the tension coil spring of L=50mm is mounted, replace it with the spring of L=60mm.
Refer to the Check, Replacement and Adjustment of Parts Volume, “9.51 Tension coil
spring” for details of the replacement procedures of the tension coil spring.
{MC:9.51 _Tension Coil Spring}