FujiFilm ClearView CS, Service Manual

Page: 436 / 1404

CR-IR 363
Service Manual
MT-279
MT-279
011-202-07
09.30.2008 FM5340
18.2.2 CPU Board
Check the CPU board.
1.
Start the MUTL.
{MU:5.2.1 _Starting the MUTL}
2.
In the MUTL, set the number of board tests to be repeated.
3.
Note the MUTL indication.
l
GOOD indication
When the number of board tests is set to “1”, 6 “RESULT-OK” indications are
displayed in MUTL. The meaning of each “RESULT-OK” corresponds as follows:
l
NO GOOD indication
The MUTL reads “RESULT: XXXX” (XXXX: error code).
If an error is detected during the board test, the error code corresponding to the
error detected on the checked location. When an error is detected, the board test
is interrupted, pand the error code is displayed again as the result of the board
check.
u
NOTE
u
A four-digit number is displayed as an error code.
Perform the troubleshooting procedure with “1” added to the head of the
displayed error code.
--Example--
When the displayed error code is “0293”:
→ Perform the troubleshooting procedures for the error of “10293”.
u
INSTRUCTION
u
If the “NO GOOD” indication is given, perform the troubleshooting procedures
again in accordance with the error code.
{MT:2. _Error Code Table}
4.
Exit the MUTL.
{MU:5.2.2 _Exiting the MUTL