FujiFilm ClearView CS, Service Manual

Page: 202 / 1404

Error
Code
Error Name Occurrence Condition
Analysis
Flow
CR-IR 363
Service Manual
MT-45
MT-45
011-202-11E
06.29.2012 FM6046
12525 Forbidden Response to INQ
command
Although the INQ command was transmitted from the RU to the CL immediately after cassette insertion during
routine processing, a rejection command was received from the CL. After the processed IP returns to a cassette,
the cassette is ejected so that the associated message appears on the RU panel.
{MT:14.}
12526 Forbidden Response to Start-
Read command
Although the Start-Read command was transmitted from the RU immediately before IP reading during routine
processing, a rejection command was received from the CL. After the processed IP returns to a cassette, the
cassette is ejected so that the associated message appears on the RU panel.
{MT:14.}
12611 Back-side PMT analog power
supply error
During bootup and routine processing, only error for the PMT analog power supply signal (+15VOKH, +15VOKL) for
back-side is detected.
{MT:5.13}
12617 Back-side High-voltage command
value error
During bootup and routine processing, error is detected only for the high-voltage command value diagnostics signal
for back-side on the SCT17B board.
{MT:5.13}
12618 Back-side High-voltage detection
value error
During bootup and routine processing, error is detected only for the high-voltage detection value diagnostics signal
for back-side on the SCT17B board.
{MT:5.13}
12642 Back-side scanner control board
error (2)
During routine processing, because the PMR high-voltage value is not set correctly on the SCT17B board, error is
detected for the high-voltage command diagnostics for back side.
{MT:5.19}
12651 Back-side photomultiplier control
board error (1)
During bootup and routine processing, only error for the PMR analog power supply signal (+15VOKH, +15VOKL) is
detected (detail code: 008100). Note that if the HV is OFF, the detail code is 008000.
{MT:5.13}
12652 Back-side photomultiplier control
board error (2)
During bootup and routine processing, only error for the high voltage power supply signal (HVOKH, HVOKL) for
back-side is detected.
{MT:5.13}
12687
Image data variation or back-
side image signal connector error
during routine processing
An abnormal image data change was detected when the image data transfer diagnostics was conducted for scanner
diagnostics during routine processing.
In the image data transfer diagnostics for scanner diagnostics during routine processing, an abnormal virtual data
change, disconnected image signal connector, or erroneous connector connection was detected.
{MT:5.18}
12695 Back-side scanner send/receive
error
During bootup, or during routine processing, or in the Maintenance Utility, control communication between the
CPU91A board and SCT17B board is performed; however, because error for the scanner unit is detected, the
control communication does not end normally.
{MT:5.19}
12696 Back-side scanner send sum
check error
During bootup, during routine processing, or in the Maintenance Utility, control communication between the CPU91A
board and SCT17B board can be done; however, sum check error is detected from the SCT17B board.
{MT:5.19}