FujiFilm ClearView CS, Service Manual

Page: 215 / 1404

CR-IR 363
Service Manual
MT-58
MT-58
011-202-11E
06.29.2012 FM6046
4. Error Code Analysis Flow:
Mechanism
4.1 Error Code Analysis Flow: Mechanism 1
10343, 10344, 10346
n
Analysis Flow
Check the error log in the ERROR DB. m
The indicated error is at the beginning of the error log?
{MT:1.4 _Troubleshooting from Error Log}
Q1
Check the error code table again for the error at the beginning, and troubleshoot.
{MT:2. _Error Code Table}
N
Y
Power supply error (12810-12875) occurs?
Q2
Check the error code table again and troubleshoot.
{MT:2. _Error Code Table}
Y
N
m
Perform preparation procedures in the order named.
1. Secure space for servicing the machine.
2. Remove the covers.
3. Turn OFF the high-voltage switch of the SCN17A/SCT17B board.
A
m Check the voltage on the CPU91A and DRV17A boards.
{MT:8. _Procedures for Checking the Voltage}
CPU91A, DRV17A/B, and SNS17A/B boards tested in MUTL normal?
{MT:18. _Board Test in MUTL}
Q3
N
Y
Q9
Q4
Check the sensor (SC3).
{MT:10. _Procedures for Checking the Sensors}
Q4
Check the sensor (SG1).
{MT:10. _Procedures for Checking the Sensors}
Q5
Check the motor (MB2).
{MT:11. _Procedures for Checking the Motors}
Q6
Check the motor (MC3).
{MT:11. _Procedures for Checking the Motors}
Q7
Error recurs?
Q8
N
Y
A
m Replace the boards in the order named.
1. SNS17A/B board
{MC:13.7 _SNS17B/SNS17C/SNS17E Board}
{MC:13.8 _SNS17A/SNS17D Board}
2. DRV17A/B board
{MC:13.5 _DRV17A Board}
{MC:13.6 _DRV17B Board}
3. CPU91A board
{MC:13.2 _CPU91A Board}
Reseat the error-causing board and check if the error occurs again.
Q9
N
Y
A
m
Replace the error-causing board.
{MC:13.2 _CPU91A Board}
{MC:13.5 _DRV17A Board}
{MC:13.6 _DRV17B Board}
{MC:13.7 _SNS17B/SNS17C/SNS17E Board}
{MC:13.8 _SNS17A/SNS17D Board}