Foma SO903iTV, Manual

Page: 38 / 390

36
Before Using the Handset
WORLD WING
WORLD WING is the DoCoMo’s FOMA international roaming service that enables you to place or receive a call
using the same mobile phone number even if you are overseas, just by replacing the UIM (green/white) with a
card for a WORLD WING service-compatible FOMA terminal or overseas-use mobile phone (W-CDMA or GSM
system).
※ If you subscribed to the FOMA services after September 1, 2005, you already have WORLD WING and no
application is required. If you declined to use WORLD WING when you subscribed to the FOMA services or
cancel the WORLD WING service halfway, you need to make an application to use WORLD WING.
※
If you subscribed to the FOMA services before August 31, 2005 and did not make an application to “WORLD
WING”, you need to make a separate application.

This service is not available in some service charge plans.
 If you should lose your UIM (green/white) or have it stolen abroad, please report it to DoCoMo and take
steps to cancel the use of the UIM as soon as possible. For information on where to call, see “General
Inquiries” on the backcover of this manual. Note that you are still liable for the call and communication
charge incurred after the loss or theft occurred.
Attaching and Removing the Battery Pack
When attaching/removing the battery pack, make sure to power off and fold the FOMA
terminal.

If you attach the battery pack forcibly, the terminal on the FOMA terminal may be damaged.

Holding too hard or attaching/removing the back cover in a manner other than described below may damage it.
■ Attaching the battery pack
1
Slide to remove the back cover
in the direction of the arrow
while pressing it at the raised
portion with your finger.
Raised portion
2
Hold the battery pack with the
recycle-mark side up, align the
terminal of the battery pack with
that of the FOMA terminal, and
push it into place.
Terminal
3
Align the back cover with the
grooves on the FOMA terminal
while holding it almost closed
(about 2 mm clearance) and
slide it in the direction of the
arrow.
■ Removing the battery pack
1
Slide to remove the back cover
in the direction of the arrow
while pressing it at the raised
portion with your finger.
Raised portion
2
Raise to remove the battery
pack in the direction of the
arrow by holding it by the tab.
Tab
● When you attach the battery pack, make sure that any portion of the UIM tray is not sticking out. If the tray
is not inserted completely, it prevents the insertion of the battery pack. If you use force to attach the battery
pack, the UIM or tray may be damaged.