FDI P2131, Technical Manual, Page: 77 / 161

CHECK OPERATION
21. Verify that all items are in the SAB and then place the SAB inside the
chamber of the SMU. Close and tighten the chamber door. Leave the
door snug but not fully tightened.
22. Reference steps 1 through 9 from Section 3.1 ‐ Installation and Setup
to fold up endcaps on SMU. Using light oil, lubricate endcap hinges
and threaded portion of endcap knobs.
23. Perform TDS water quality test to ensure SWS is correctly deionizing
the water. Replace cartridge as needed. See Section 3.4.1.
24. Remove the inlet and outlet hoses on SWS. Remove the blue
housing and turn upside down to allow the water to drain completely
from the inlet/outlet. Place back into frame, connect outlet hose,
and ensure manual valve is closed. Connect manual pump outlet
hose to inlet of SWS. Wrap and secure all hoses for transport.
NOTE: On S/N’s after AFS ‐ 0255, all hoses can be stored in the SWS
frame. Release the Handle Latches to fold the handle down and store
all hoses inside the frame. Close the Handle and secure the two
Handle Latches.
Checklist for Transport and/or Storage (continued)
71