FDI P2131, Technical Manual, Page: 41 / 161

Water Recovery System (WRS)
The WRS reclaims steam and condensate from the SMU for re ‐ use. A circulation pump and heat
exchanger allow for hot steam to be cooled and condensed into water. A water eductor creates
a vacuum during the preconditioning phases to remove air and provides a deep vacuum to assist
in drying a load during the dry phase. The WRS also provides an easy, push ‐ button method to
refill the SMU jacket.
NOTE: The Power Switch on the WRS should always be in the ON position during operation.
Right Side of WRS
6. Tank Drain
Connection
(P/N: P2131 ‐ 2 ‐ 0045)
7. Water Fill
Connection
(P/N: P2131 ‐ 2 ‐ 0046)
3. Water Return Switch (SW ‐ 2)
(P/N: P2131 ‐ 2 ‐ 4009)
1. LOW Water Line
2. HIGH Water Line
4. Power Switch (SW ‐ 3)
(P/N: P2131 ‐ 2 ‐ 4008)
5. Power Connection
(P/N: P2131 ‐ 2 ‐ 4010)
8. Motor Access Hole
(Note: On S/N’s after
AFS ‐ 0236, this hole
no longer exists.)
9. Pump Drain Connection
(For S/N’s after AFS ‐ 0236)
(P/N: P2131 ‐ 2 ‐ 0047)
35