FDI P2131, Technical Manual, Page: 29 / 161

34. Connect the SMU power receptacle to a de ‐ energized incoming power supply to ensure
a surge ‐ free installation, and then turn on the incoming power. The layout of the power
cord should provide safe access to the sterilizer.
NOTE: User is responsible for compliance with applicable local and national electrical
codes and regulations.
35. If a pressurized potable water source is available, connect a water supply to the INLET of
the SWS. Before each use, flush SWS until water is clear (2 minutes). Before filling WRS,
check water TDS (Total Dissolved Solids) and free chlorine level. Reference Section 3.4 for
more details. See Section 2.5 – Water Supply Quality to ensure the correct quality of
feedwater is used.
CAUTION : Water in SWS can foul and become discolored if not used regularly.
36. For S/N’s AFS ‐ 0001 through AFS ‐ 0236, with the yellow valve handle as shown below,
connect the clear Outlet Hose from the SWS to the Fill Connection on the bottom of the
WRS. This is a cam ‐ style connection. Ensure WRS drain valve is closed, then open the
yellow valve on the end of the SWS outlet hose (pictured below) to allow water to flow
into the tank. Once the HIGH mark is reached, close the yellow valve at the end of the
SWS outlet.
For S/N’s after AFS ‐ 0236, connect the Outlet Hose from the SWS to the Water Fill
Connection on the WRS. Ensure the Tank Drain and Pump Drain valves are closed, then
open the yellow valve on the end of the SWS outlet hose and the blue valve on the Water
Fill Connection. Fill with water. Once the HIGH mark is reached, close the yellow valve at
the end of the SWS outlet hose and the blue valve on the Water Fill Connection.
(S/N’s AFS ‐ 0001 through 0236) (S/N’s after AFS ‐ 0236)
Water Supply Hose
Outlet Hose (To WRS)
(P/N: P2131 ‐ 3 ‐ 3006)
23