Extreme Networks ExtremeWare 7.3.0, Command Reference Manual

Page: 348 / 2254

348 ExtremeWare Software 7.3.0 Command Reference Guide
VLAN Commands
show vlan
show vlan {<vlan name> | detail | stats {vlan} <vlan-name>}
Description
Displays configuration information about specified VLANs.
Syntax Description
Default
Summary information for all VLANs on the device.
Usage Guidelines
Unlike many other vlan-related commands, the keyword “vlan” is required in all forms of this
command except when requesting information for a specific vlan.
Use the command
show vlan
to display summary information for all VLANs. It shows various
configuration options as a series of “flags” (see the example below). VLAN and protocol names may be
abbreviated in this display.
Use the command
show vlan detail
to display detailed information for all VLANs. This displays the
same information as for an individual VLAN, but shows every VLAN, one-by-one. After each VLAN
display you can elect to continue or quit.
Protocol None indicates that this VLAN was configured with a user-defined protocol that has
subsequently been deleted.
Use the command
show vlan stats <vlan name>
to show real-time statistics on the number of
packets transmitted and received for the named VLAN. This command will continue to run until you
cancel it using the [Esc] key.
Using the
detail
option of his command displays secondary IP addresses, which are displayed in the
line following the primary IP address output.
vlan-name Specifies the name of the VLAN whose configuration is to be displayed.
detail Specifies that detailed information should be displayed for each VLAN.
stats Specifies a real-time display of utilization statistics (packets transmitted and
received) for a specific VLAN.