Extreme Networks ExtremeWare 7.3.0, Command Reference Manual

Page: 1104 / 2254

1104 ExtremeWare Software 7.3.0 Command Reference Guide
ESRP Commands
disable elsm ports
disable elsm ports <portlist>
Description
Disables Extreme Link Status Monitoring (ELSM) protocol for the specified ports.
Syntax Description
Default
Disabled.
Usage Guidelines
The Extreme Link Status Monitoring (ELSM) protocol allows you to detect remote CPU failures in the
network. A software or hardware fault might prevent the CPU from transmitting or receiving, leading
to the sudden failure of the CPU. If the CPU cannot process or send packets, ELSM isolates the
connections to the faulty switch from the rest of the network. If the switch fabric continues to send
packets during a CPU failure, the switch may appear to be healthy when it is not.
An Extreme Networks device with ELSM enabled can detect remote CPU failures by exchanging hello
packets between two ELSM peers. When ELSM detects a CPU failure as a result of not hearing from its
neighbor, it brings down the connection to the neighbor. ELSM operates on a point-to-point basis; you
only configure ELSM on the ports that connect to other devices within the network, but you must
configure ELSM on both sides of the peer connections.
ELSM ports use hello packets to communicate information about the health of the network to peer
ports. The hello packets are received and transmitted by an ELSM-enabled port. The port expects a
response from its neighbor after it sends a hello packet.
When you enable ELSM on the specified ports, the ports participate in ELSM with their peers and begin
exchanging ELSM hellos. Use the following command to enable ELSM:
enable elsm ports <portlist>
ELSM works between two connected ports, and each ELSM instance is based on a single port.
When you disable ELSM on the specified ports, the ports no longer send ELSM hellos to its peer and no
longer maintain ELSM states.
Example
The following command disables ELSM for ports 1-6 on the switch:
disable elsm ports 1-6
portlist Specifies the ports or slots and ports for which ELSM should be disabled. May
be in the form 1, 2, 3-5, 2:5, 2:6-2:8.