Elgo P40T-002 Series, Operating Manual

Page: 28 / 88

Service Mode / Parameter Level
- 28 -
11.4.1 Axis Type IN / OUT
Table 1: Define Type of Axes
11.4.2 Reference Mode
The mode for axis referencing is defined in this register (see also

10.4 Reference an Axis):

Mode 1 = referencing by parameter

Mode 2 = referencing by target value

Mode 3 = reference run positive with index impulse
11.4.3 Software Endposition
Software-end positions can be activated or deactivated with this parameter:

both enabled

negative disabled

positive enabled

both disabled
11.4.4 Decimal Point

without

1/10

1/100

1/1000
Backgauge Parameters Gap and Angle Parameters
Encoder – Dig Disabled
Analog – Dig Encoder – Dig
Encoder – Digital Analog – Dig
Encoder – PID+Digital Encoder – Digital
Analog – Digital Encoder – PID+Digital
Analog – Digital