Elgo P40T-002 Series, Operating Manual

Page: 23 / 88

Operation Modes
- 23 -
10.3.2 Create a Program
Following parameters and values are valid for the entire program (resp. are similar for all program blocks):

Material type
 Material thickness

Pressure

Gap
 Angle
1. Select a free program from the program list (

10.3 Program Mode) resp. delete an existing program.
Now the current data set should be 1.
2. Define if necessary material type and thickness or pressure, gap and angle
(applies to the entire program).
3. Define a position for backgauge and if necessary a value for cut length and cut offset.
4. Switch to next data set.
5. Repeat steps 3. and 4. until all desired data sets are defined.
6. Finally, the end of the program must be defined. To do this, open the "current data set" window and
activate the "E" field for End. This marks the end of the program in the last data set as character "E".
Figure 18: Define the “End of Program”
Mark the last data set of the program with „E“ (End).