Elgo P40T-002 Series, Operating Manual

Page: 76 / 88

Type Designation
- 76 -
15 Type Designation
NOTE
When ordering, please use the here described ordering code (Type Designation).
Options that are not required are filled in with „-„.
P40T 024 XX
Type Designation:
P40T = Touchscreen Position Controller
(for 1 or 2 axes)
Power Supply Voltage:
024 = 24 VDC (+10 / -20 %)
Encoder Inputs (per Axis):
X = Input is not available
1 = A, B, Z (PNP) 24 V supply / HTL, 100 kHz
2 = A, A‘, B, B‘, Z, Z‘ 24 V supply / TTL 100 kHz
3 = A, A‘, B, B‘, Z, Z‘ 5 V supply / TTL 100 kHz
4 = 1 analog inputs 3.3 V supply / 0 ... 3.3 V (12 bit)
1
5 = 2 analog inputs 3.3 V supply / 0 ... 3.3 V (12 bit)
2
6 = A, B, Z (PNP) 24 V supply / 0 … customer spec., max. 24 V
7 = 3 analog inputs 3.3 V supply / 0 ... 3.3 V (12 Bit)
2
Version:
002 = Version for guillotine shears
-
Options:
X = no further options
C = screw terminals
8 = 8 digital inputs / 8 digital outputs
5
S = serial RS232 interface
N = digital inputs in NPN version
XXXX - - - 000 XX -
Restrictions:
Analog Output (per Axis):
X = no analog output (switch-off positioning)
1 = 12 bit analog output ±10 V (PID regulated)
4
2 = 12 bit analog output ±10 V (unregulated)
1
for special applications (e. g. as auxiliary axis)
2
for special applications, analog inputs only for and on two axes
3
for special applications and only possible for 2. Axis
4
not possible with "Encoder Inputs = 4 or 5“
5
not possible for two axes and not possible with analog output
Note: Digital switching outputs (transistor, PNP) are generally available for each axis in terms of software and hardware.