Elgo P40T-002 Series, Operating Manual

Page: 56 / 88

Service Mode / Parameter Level
- 56 -
11.15.1 Conveyor Belt
Function:
The output “conveyor belt” is set if:
1. The function is activated by soft key in single or program mode
2. The cutter bar is in the Top Dead Center
Since the state is not saved, the conveyor belt function must be reactivated each time the single or program
mode is selected.
11.15.2 Autocut
Function in Single Mode:
If the Autocut function is activated and the "Start cut" input is set continuously (e.g. by a foot pedal), a new cut is
triggered after the cut has been completed until either the defined quantity is reached or the "Start cut" input is
reset.
Function in Program Mode:
In program mode, the cut must be retriggered for each data set. A data set is processed in the same way as in
single mode. When the end of the program is reached, the shear also stops.
The time between two cuts can be set in both operating modes via the parameter "Delay Autocut" in the menu
Service-  Cutting .
11.15.3 Backgauge Park Position
Function: When this function is activated, the backgauge is moved to the parking position.
The corresponding position is entered in the menu
Service  Soft-Keys  parkposition .
The activated function is displayed in color at the soft key. Pressing START deactivates the "Backgauge park posi-
tion" function and moves the back gauge to the specified target position.
11.15.4 Support (Sheet Support)
Activates the soft key "Sheet Support". Refer to

11.11.1 /

11.11.2 /

11.11.3 for respective functions.
11.15.5 RTO
Activation of the “RTO” soft key. Only with activated “Sheet Support” possible.
Function of the soft key in single or program mode:

Soft key RTO activated

A cut is made

Support above

Sheet thickness and length within the specified range

Button RTO activated

As long as the button is pressed, the sheet is pushed forward with the back gauge,
but maximum over the length entered in the parameters.
11.15.6 Position Value Park Position
Position to which the stop is moved if the function „Backgauge park position“ is activated (

11.15.3).
11.15.7 Scrap Shaft
If the Scrap Shaft option is activated, the scrap shaft can be activated in single and program mode. The corre-
sponding output is simply switched ON or OFF.