Elgo P40T-002 Series, Operating Manual

Page: 17 / 88

Operation Modes
- 17 -
10 Operation Modes
10.1 Single Mode
In single mode, a single block can be processed. Each entered target position must be confirmed with “OK”.
In single mode it is also possible to load the target position for the axis “Angle” and “Gap” from a material
table. The fields “Material selection” and “Material thickness” are located on the left side of the menu.
After one of the two fields has been changed and the new value has been confirmed, the corresponding target
positions for axis “Angle” and “Gap are displayed. It is also possible to assign a value each for the "Cut Length"
and "Cut Offset".
The material properties can be changed via the material table. This is loaded by pressing the material selection
key for longer than 5 seconds. After releasing the key, the material table opens. Either the password 2505 for
the material table or the service password (250565) is required for access.
Figure 8: Single Mode
Figure 9: Numerical input fields of Axis Parameters
Activated Soft Key
Gap Width
Angle
Soft Key
Start Escape / Back
Cut Offset
Cut Length
Quantity
Pressure
Material Thickness
Backgauge
Material Selection
Single Mode
Cancel / Exit
Sub Menu
Change sign
Selected Axis
Clear Input
Enter
Target Value
Allowed Range
Referencing