Doc
#
E154713
11-27
11: Using the I/O Options
Electro
Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
11.8.8.2: Communication
Maximum registers per request, read or write, is 4 registers.
The device operates with the following default parameters:
Address
247 (F7H)
Baud Rate
57600 Baud
Transmit Delay Time
20 msec
11.8.8.3: Normal Mode
Energy readings are given to the device frequently. The device generates a pulse at
each channel after a certain energy increase.
Normal operation consists of three processes:
1. The first process accepts writes to registers 04097 - 04112. Writes can be up to
four registers long and should end on the fourth register of a group (register
04100, or registers 04103-04112 or registers 04109-04112). These writes can be
interpreted as two-byte, four-byte, six-byte or eight-byte energy readings. The
reception of the first value for a given channel provides the initial value for that
channel. Subsequent writes will increment the residual for that channel by the dif-
ference of the old value and the new value. The previous value is then replaced
with the new value. Attempting to write a value greater than the programmed roll-
over value for a given channel is completely ignored and no registers are modified.
If the difference is greater than half of the programmed rollover value for a given
channel, the write does not increment the residual but does update the last value.
Overflow of the residual is not prevented.
2. The second process occurs in the main loop and attempts to decrement the
residual by the programmed Energy/Pulse value. If the residual is greater than the
programmed Energy/Pulse value and the Pending Pulses value for that channel has
not reached the maximum limit, then residual is decremented appropriately and
the Pending Pulses value is incremented by two, signifying two more transitions
and one more pulse.
3. The third process runs from a timer that counts off pulse widths from the
Programmable Minimum Pulse Width values. If there are pulses pending for a
Summary of Contents for Shark 100T
Page 1: ...V 1 04 May 15 2018 ...