XDM-300 Installation and
Maintenance Manual
Equipment
Installation
417006-2311-0H3-A00 ECI
Telecom
Ltd.
Proprietary
3-65
7.
Fasten the module to the adapter by tightening the two fastening screws. Do
not use excessive torque when tightening the screws.
8.
Install the SFP transceiver according to Installing SFP/XFP transceivers in
optical/CWDM modules and cards (on page
).
Installing SFP transceivers in optical
modules
C
AUTION
:
During the installation of SFP/XFP transceivers
in optical or CWDM modules and cards, make sure that all
optical LC connectors are closed by protective caps. Do not
remove the covers until an optical fiber is connected to the
corresponding connector.
To install SFP/XFP transceivers in optical or CWDM I/O
modules and cards:
1.
Identify the prescribed position on the module according to the site
installation plan.
2.
Check that the SFP/XFP has not been physically damaged during shipment,
and that the antistatic protection bag of the original packaging is sealed.
3.
Remove the SFP/XFP from its antistatic protection packaging and perform
a visual inspection to detect damage during shipping. Report any problems.
4.
Record the hardware and software versions indicated on the SFP/XFP
identification labels.
5.
Remove the protective covers from the slot and from the SFP/XFP
transceiver.
6.
Insert the rear end of the transceiver into the slot guides, and push slowly
backwards to mate the connectors until the transceiver clicks into place. If
you feel resistance before the connectors are fully mated, retract the
transceiver and repeat the procedure.
Summary of Contents for XDM-300
Page 1: ...XDM 300 Installation and Maintenance Manual Version 7 417006 2311 0H3 A00...
Page 2: ......
Page 8: ......
