Maintenance
XDM-300
Installation
and
Maintenance Manual
4-26 ECI
Telecom
Ltd.
Proprietary
417006-2311-0H3-A00
Replacing SFP/XFP Transceivers
ECI Telecom's Transport Networking Division supplies field-replaceable
SFP/XFP transceivers. Hot swapping is allowed, provided you observe all the
safety precautions described in Before You Start (on page
) during the
replacement.
To replace an SFP/XFP transceiver:
1.
Mark each fiber connected to the transceiver for identification purposes.
2.
Identify the position of the SFP/XFP transceiver to be replaced.
3.
Disconnect the fibers connected to the transceiver.
4.
Remove the transceiver plug-in by pulling its tab.
5.
Insert the rear end of the replacement transceiver plug-in into the prescribed
position, and push slowly backward to mate its rear connector with the
corresponding optical interface module connector until the transceiver
clicks into place (see the following figure). If you feel resistance before the
transceiver plug-in is fully inserted, retract the transceiver and repeat the
insertion.
Figure
4-4: Inserting an SFP/XFP transceiver into an I/O module
6.
Reconnect the fibers disconnected in Step 3.
Summary of Contents for XDM-300
Page 1: ...XDM 300 Installation and Maintenance Manual Version 7 417006 2311 0H3 A00...
Page 2: ......
Page 8: ......
