Page 10 of 126
198-0853-02 Rev F
11. If this power supply weighs more than 40lb / 18kg (see Section 4 - Specifications), it must
be lifted by two persons. Always use proper lifting technique.
12. Use of this product for purposes other than those specified in this manual is not
recommended. Use for other purposes may give unexpected results or cause damage to
the power supply and/or the system it is being used in.
3. Functional Overview
The LT1200X series plating power supply is a compact, high power unit that offers a wide range of
features for the plating industry. It has universal power input with power factor correction. The
power supply has a sealed design with a fan cooled heat sink tunnel. The unit is packaged in a
316 stainless steel ½ rack sized enclosure.
The LT comes with a Smart user interface. The user can set and monitor the voltage and current
and there are indicators for errors and status of the unit. The settings are changed using multi-
turn encoders. The encoders have pushbutton switches for changing the meter display from the
readings to the settings for visual adjustment of the set point. By using the proper settings the
power supply can be set to run in current, voltage or crossover regulation modes.
The LT Smart user interface contains menus that allow various features to be configured and
provide for display of information regarding cycle status.
The LT supports the following features
Manual Cycle Control
Real Time Cycle Control (RTC)
Amp Time Cycle Control (ATC)
User Configurable Totalizer
Over Temperature Warning (before shut down)
Over Temperature Shut down
Fan speed based on internal temperature
Configurable Power Up Mode (always in standby, or in last mode)
Remote operate/standby control (isolated digital input)
Host port (RS485)
Optional analog control (4-20mA, 05V, 0-10V)
Digital Calibration
Alarms and diagnostics