Draytek Vigor2912 Series, User Manual

Page: 118 / 422

Vigor2912 Series User’s Guide 108
practical bandwidth for your WAN interface, please choose
the setting of
According to Line Speed . Otherwise, please
choose Auto Weigh to let the router reach the best load
balance.
IP Based - The same source / destination IP pair will select
the same WAN interface as policy. It is the default setting.
Session Based - All of the WAN interfaces will be used (as
out-going WAN) for passing through new sessions to get
better transmission speed. Though good speed test result for
throughput might be reached; however, some web site may
not open smoothly, especially the site need authentication,
e.g., FTP.
If you have no strong demand about speed test result, keep
default settings as IP based.
Index Click the WAN interface link under Index to access into the
WAN configuration page.
Enable V means such WAN interface is enabled and ready to be
used.
Physical Mode / Type Display the physical mode and physical type of such WAN
interface.
Line Speed Display the downstream and upstream rate of such WAN
interface.
Active Mode
Display whether such WAN interface is Active device or
backup device.
Note: In default, each WAN port is enabled.
After finished the above settings, click OK to save the settings.
W
W
A
A
N
N
1
1
/
/
W
W
A
A
N
N
2
2
w
w
i
i
t
t
h
h
E
E
t
t
h
h
e
e
r
r
n
n
e
e
t
t
a
a
n
n
d
d
F
F
i
i
b
b
e
e
r
r
W
W
A
A
N
N
WAN1 is dedicated to physical mode in Ethernet (Vigor2912/Vigor2912n) or Fiber
(Vigor2912F/Vigor2912Fn). WAN2 is dedicated to physical mode in Ethernet.