Docomo prosolid II foma P851i, Manual

Page: 56 / 488

54
Making
a
Call
Making
Calls/Receiving
Calls
■
Auto-redialing
If the video-phone call is not connected, dialing at 32K or the voice call is automatically made.
● The video-phone call by 32K speed is provided to connect with PHSs and similar devices that cannot be connected at 64K
depending on the network conditions. When you dial a 64K video-phone call to the phone that can be connected only at 32K, the
dialing speed will be switched automatically to 32K.
※
The same digital transmission charge applies to the 32K video-phone connection and 64K digital connection.
●
Video-phone calls cannot be connected to phones if they do not support the video-phone function, are out of the service area, or
are switched off. If you have set “Voice call auto switch” to “ON” and attempt to dial a phone that does not have the video-phone
function, the video-phone call will be cut off and the number will be redialed as a voice call. Note that this setting might not work if
you call an ISDN synchronous 64K or PIAFS access point or an ISDN video-phone that does not support 3G-324M (as of
November 2005), or if you dial the wrong number. Nevertheless, you could be charged for the call.
●
After the video-phone call start communications, redialing as the voice call will not be made.
● You can press the numeric keys to send touch-tone signals during a call. However, switch to the DTMF transmission mode if during a
Chara-den call.
⇒
See page 85
●
Note that when you make a video-phone call sending a substitutive image, you will be charged for the digital transmission.
●
During a voice call or during sending/receiving data by packet communications, you cannot make a video-phone call.
●
If you dial 110, 119 or 118 using the video-phone function, the number will be automatically dialed out as a voice call.
● You cannot receive mail and Messages R/F during a video-phone call. Incoming mail and Messages R/F will be held at the i-mode
Center. You can retrieve them using “Check new message”, after you end the video-phone call.
However, you can receive SMS messages during a video-phone call.
●
During Hands-free use, be sure to keep the FOMA phone away from your ears. Otherwise, you could affect or damage your hearing
with sound from the speaker.
● If the battery becomes low during a Chara-den call and “Recharge battery” is displayed, the image switches to the pre-installed substitute
image. In this case, if you charge the battery during a video-phone call, the image set for “Substitutive image” of “Select image” is dis-
played.
●
You cannot make a video-phone call by entering a phone number while “Keypad dial lock”, “Restrict dialing” or “Self mode” is activated.
●
The International video-phone call is available using the DoCoMo International Call Service “WORLD CALL”.
⇒
See page 55
■
When a video-phone call cannot be connected
When a video-phone call cannot be connected, the reason is displayed. (The displayed reason might not be the same as the actual
reason depending on the other party’s phone and contract for network services.)
Messages Reasons
Check the number and retry You have dialed a wrong phone number.
Busy The line is busy or during packet transmission.
Out of service area or power off The other party’s phone is out of the service area or turned off.
Select on for Call ID Notification Your caller ID is not notified.
(when dialing “V-live” or “Visualnet” and so on)
Your call is being forwarded When forwarding.
Please redial phone call Either the other party activates Voice Mail Service or forwarding destination
phone does not support the video-phone call.
Failed to connect Redial after setting “Activate” of “Caller ID notification” to “ON”.
・
This may appear in the case other than above.
Driving mode The other party activates Drive Mode.
Information
Voice call auto switch “ON” Voice call auto switch “OFF”
Could not connect by dialing at 64K. Dials again at 32K. Dials again at 32K.
Could not connect by dialing at 32K. Dials again by the voice call. Does not dial again.
• When you hear the busy tone, the other party may set “Reject Video-phone ” to “ON”. In this case, the ring tone does not sound,
and the missed call record remains in the other party’s phone.